|
|
|
#1
|
|||
|
|||
Climate Control prolem 126 Chassis
Hello I have a 83 300SD that the climate control is not operating properly. It will not activate the blower unless you roll the temp dial all the way down to max cold. I tried changing the blower relay that sits beside the fan but that was not the problem. Any help would be greatly appreciated. Thanks in advance.
__________________
DRIVE HARD-DRIVE FAST-DRIVE TO GET THE HELL OUT OF MY WAY. 1986 190E 2.3-16 Pearl Black!! 1987 190E 2.3-16 Smoke Silver!! 1986 190E 2.5-16 Pearl Black!! 2004 CLK 500 Cabrio Designo package!! 1994 E320 Cabrio Red with black top!! 1985 500 SEL Anthracite Grey !! 2011 Subaru Impreza STI 380HP (Yeah Baby) |
#2
|
||||
|
||||
If it works at max cold and max heat (check that), then blower speed #6 is OK. Could be the wire wound resistor pack is out for the other speeds. The "toaster is between the two firewalls near the brake booster.
__________________
The Golden Rule 1984 300SD (bought new, sold it in 1988, bought it back 13 yrs. later) |
#3
|
|||
|
|||
Blower operation
Thanks for the reply. I found the problem to be the cold lock out switch at the thermostat housing.
__________________
DRIVE HARD-DRIVE FAST-DRIVE TO GET THE HELL OUT OF MY WAY. 1986 190E 2.3-16 Pearl Black!! 1987 190E 2.3-16 Smoke Silver!! 1986 190E 2.5-16 Pearl Black!! 2004 CLK 500 Cabrio Designo package!! 1994 E320 Cabrio Red with black top!! 1985 500 SEL Anthracite Grey !! 2011 Subaru Impreza STI 380HP (Yeah Baby) |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|