|
|
|
#1
|
|||
|
|||
Help! Transmission Separation from Engine
Engine and transmission are removed from car,1980 300 SD. I have removed all the bolts from the perimeter of the engine/transmission connection and the transmission will slide away about 1/2 inch and no more. Is there some internal fastener that needs to be released??? I am trying to retain the tranny and dump the bum engine Appreciate any help. Willie,(Poor Soul)
|
#2
|
|||
|
|||
No internal fastener.
Did you take out the 6 bolts holding the torque converter to flywheel ? Not required, but then torque converter comes off with trans. If not, did you remove the cover plate on bottom of trans that would be hitting the flywheel and not let it slide back ? The only other thing that happens os the torque converters stick on the back of the crankshaft, very close tolerences here. Careful prying usually gets it to come off.
__________________
80 300D 340K Owned 30 yrs 83 300SD 440K Owned 9 yrs - Daily Driver 150mi/day 02 Z71 Suburban 117,000 15 Toyota Prius 2600 miles 00 Harley Sportster 24k 09 Yamaha R6 03 Ninja 250 |
#3
|
|||
|
|||
I assume access to 6 bolts is thru the hole in bottom of bell housing--but first- I will check for cover plate as mentioned. Many thanks; Poor Soul is not the greatest mechanical wizard and any help is greatly appreciated.
|
#4
|
||||
|
||||
Quote:
|
#5
|
|||
|
|||
Sweet Success!!!! I removed the six bolts as mentioned and the motor and transmission separated immediately. There is no cover plate that I could see. I really appreciate the help. Many thanks for your responses. Is this forum great or what? Willie(Poor Soul)
|
Bookmarks |
|
|