|
|
|
#1
|
|||
|
|||
I tried to get a drivers side rear view mirror for my 1982 380 SEC through the dealer. no such luck they are back ordered in Germany.
does anyone have any ideas where I can get my hands on one? Ive tried the salvage yards and no one has one. thanks Benzat 1982 380 SEC |
#2
|
|||
|
|||
Where are you?
|
#3
|
|||
|
|||
Im in Virginia Beach Virginia
|
#4
|
|||
|
|||
Uh-oh, SEC is a W126, isn't it? I was thinking W123. I've seen several 123's at local salvage yard (used parts supplier) with good exterior mirrors. I've been thinking that I may get a replacement right hand mirror on my 81 300D, and may be able to get a left one for you at same time. In fact, I just remenbered: I have a left mirror from '85 SEL (W126) in my attic - I'm suddenly thinking it may be same as yours. (I needed a left front door several years ago on my 91 350 SDL (W126), and I used a door from and '85 SEL; I have the mirror from it.) Describe your miror; does it have gray plastic on front side, etc? This one does.
|
#5
|
|||
|
|||
Looks like part # on the one I have is 126 810 45 16; manually adjusted; elec. wires going in it - possibly for heating? Almost perfect cond. - small 1/8" by 1/4" scratch near outer edge of gray plastic, front cover.
|
#6
|
|||
|
|||
there are no wires on mine..its non electric and non heated for the drivers side.
the coupes and sedans have different mirrors the part number from the dealer is 126-810-11-16-7175 and 126-811-03-60-7174 that is for the housing and the mirror itself. Benzat 1982 380 SEC |
#7
|
|||
|
|||
BTW, the part # is on surface thats mounted up against the door, by the upper mounting screw - you have to remove the mirror to seed the #.
|
#8
|
|||
|
|||
there is grey on the back side of the housing to match the car. and its black on the plastic part
benzat 1982 380 SEC |
#9
|
|||
|
|||
'Don't have to use heating, of course. IMPCO cat. shows same mirror for "All models to 1985 except 500SEC; Pre-1982 requires mirror control knob". This one has control knob, of coursee.
My thought was that sedan & coupe may be different, but note the IMPCO comment. I don't know - not sure. This one is the entire assembly, of course. |
#10
|
|||
|
|||
Black rubber around the outer edges of the part sticking out around the mirror, itself (mirror housing); black rubber, triangular-shaped area up against the door and covering the "hinge" ("break-away") mechanism.
|
#11
|
|||
|
|||
Should IMPCO cat. say "--- except ALL SEC's"? 'Don't know.
|
#12
|
|||
|
|||
the rubber piece is just fine I can not control the movement of the mirror and the state inspection of VA wont pass the car because of that.
Ill have to try a few other places on Monday thanks for your help hope you can help me in the future when I get down to having this thing restored. Benzat 1982 380 sec |
#13
|
|||
|
|||
just a warning about getting parts from IMPCO they dont always work..and dont look like OME products. so they dont always fit the way they are suppose to be. I spend more time sending things back then it was worth to order.
If you have a Bap Geon around the products are much better and alot less expensive than Imco. benzat 1982 380 SEC |
Bookmarks |
|
|