|
|
|
|
|
#1
04-06-2006, 11:03 PM
|
||||
|
||||
How do I take out the back seat w126?
Planning to run a bunch of wires to and from the trunk for some nutty modifications I'm planning... I have the seat bottom out but the back doesn't seem to come off very easily...
Once the bottom was of I saw the rail that slides the whole assembly back and forth and disconnected the seat heater things... but i still can seem to get the back off I'm sure there has to be something toward the top of the seat back that I'm not seeing from underneith... Please help... Thanks in advance for your guidance...
__________________
iThink Different Building an all new electrical system in my 1985 500SEL Last edited by whunter; 04-06-2006 at 11:33 PM. 
|
|
#2
04-06-2006, 11:32 PM
|
||||
|
||||
|
Answer
Replacing the Rear Shocks & Springs
on the W126 1985 300SD http://www.peachparts.com/Wikka/W126RearShocksSprings Have a great day.
__________________
ASE Master Mechanic https://whunter.carrd.co/ Prototype R&D/testing: Thermal & Aerodynamic System Engineering (TASE) Senior vehicle instrumentation technician. Noise Vibration and Harshness (NVH). Dynamometer. Heat exchanger durability. HV-A/C Climate Control. Vehicle build. Fleet Durability Technical Quality Auditor. Automotive Technical Writer 1985 300SD 1983 300D 2003 Volvo V70 https://www.boldegoist.com/
|
|
#3
04-06-2006, 11:53 PM
|
||||
|
||||
|
There are a few fasteners on the bottom to remove then just lift the whole seatback up. There are clips at the top that fit into slots.
__________________
Regards Warren Currently 1965 220Sb, 2002 FORD Crown Vic Police Interceptor Had 1965 220SEb, 1967 230S, 280SE 4.5, 300SE (W126), 420SEL ENTER > = (HP RPN) Not part of the in-crowd since 1952.
|
|
#4
04-07-2006, 12:27 AM
|
||||
|
||||
|
I think i found what was holding me down... because it's a moving electric seat, it has a few pivioting things near the top... i'm tring to get them apart only because it looks like it was made to come apart...
__________________
iThink Different Building an all new electrical system in my 1985 500SEL
|
|
#5
04-07-2006, 12:46 AM
|
||||
|
||||
|
Got it!
After disconnecting the two 10mm bolts from the slider on the bottom i had to pop out two hard to reach pins near the top of each side of the back back... Once those were out... I untangled the seat belts and it was out!
__________________
iThink Different Building an all new electrical system in my 1985 500SEL
|
 |
| Bookmarks |
|
|
Linear Mode
