|
|
|
#1
|
|||
|
|||
connection to dist. caps
help, just changed dist caps on my 94 E500. GOOFY ME, i did not mark down wiring order of dist caps. appreciate for schematic of distributor caps.thanx
|
#2
|
|||
|
|||
ph7, if you're using Bosch distributor caps the terminal numbers are marked with left and right designations. If the new caps aren't marked go to thebenzbin.com and search under 1994 MB, E500, Engine Electrical, Distributor Cap. Enlarge the thumbnail of the Bosch distributor cap so you can read the terminal markings.
__________________
Fred Hoelzle |
#3
|
||||
|
||||
or ,go to DIY section here and look at dist cap and rotor replacement article.
__________________
95 E420 ( 76K) SOLD 85 380SE(125k) 95 SL500(72k) |
#4
|
|||
|
|||
dist caps
thanx for the info. i did that, but which wire from pass side to DRIVER cap or vice versa? help. this is a cool sight. my first time as a user. thanx a million.
|
#5
|
||||
|
||||
I believe the DIY points out that the right side of the engine is on the right if you are sitting in the car. If you are standing in front of the car athen the right side is on your left. The dist caps have a R/L on each connection post along with the wire /cylinder #. depending whether its the right or left. If your wires are numbered then connect that number to the number on the cap depending if it is on left or right.
Example: one post will say R4 and L5, so if you are connecting the right side of the engine wires then the number 4 cylinder wire goes on this post
__________________
95 E420 ( 76K) SOLD 85 380SE(125k) 95 SL500(72k) |
#6
|
|||
|
|||
dist caps
Gary, in diy does not show on passenger side will connect which wire number like 1-4-7-6 or vice versa. i changed the whole set of wires, just do not know on passenger dist cap which wire to plug in with? now ASR light is on? how do i reset it? thanx. ph7
Last edited by ph7; 05-09-2006 at 10:05 PM. |
#7
|
||||
|
||||
Ok I'm not 100% positive on this but your manual should show the firing sequence of the cylinders. If you standing in front of the car then the left side is 5--8 front the front and the right side is 1-4 from the front. If the firing order is 1-5-4-8-6-3-7-2 then the wire from #1 would go on the L 1 connection on the right side dist cap, then the #2 on the L 2 and so on. Its confusing because when facing the car the right side is actually the left
__________________
95 E420 ( 76K) SOLD 85 380SE(125k) 95 SL500(72k) |
#8
|
|||
|
|||
dist caps
thanx gary, i will try again. god bless.
|
#9
|
|||
|
|||
connection from eng to dist. caps
help everyone, still can not connect right wire to correct dist cap for a 94' E500 does anyone know? passenger wires are 1-4-7-6 which goes to driver dist cap? almost burn my benz down!!!!! thanx in advance. ph7
|
#10
|
|||
|
|||
The cylinders are numbered like so:
4_______8 3_______7 2_______6 1_______5 Front of car The passenger side cap is 1-4-6-7 The driver's side cap is 5-8-3-2 |
#11
|
|||
|
|||
dist caps
thanx a million, bought $5.00 of gas ready to torch it, but could not still in love w/ it. ph7
|
#12
|
|||
|
|||
connection to dist caps
hi deanyel, passenger side wires from eng marking are 1-4-6-7 none of these would goes to driver cap? thanx
|
#13
|
|||
|
|||
No, each cap goes to 4 cylinders and the center wire goes to its own coil. There are two coils on the front driver's side.
|
Bookmarks |
|
|