I have had a fault with ASD light on. I was advised to check the overvolt relay fuse and it was blown . Now Ive replaced it the but light is still on. Does this have to be reset electronically ,if so, how can I do it myself?
The car is a 300CE 24v w124

__________________
Larry

IF there is a fault(code) in the system it must be scanned & the fault must be repaired. Then the code can be erased.

__________________
MERCEDES Benz Master Guild Technician (6 TIMES)
ASE Master Technician
Mercedes Benz Star Technician (2 times)
44 years foreign automotive repair
27 Years M.B. Shop foreman (dealer)
MB technical information Specialist (15 years)
190E 2.3 16V ITS SCCA race car (sold)
1986 190E 2.3 16V 2.5 (sold)
Retired Moderator

I understand this but how can I reset the fault code without going to the expense of booking the car into a main dealer .Can you for example disconnect the battery for several hour s or short out pins on the diagnostic connector etc.
This is an old system so ther must be some volatility in the fault memory . How is this backed up , a lithium cell? capacitor? or perhaps a relay is latched.

__________________
Larry