|
|
|
#1
|
|||
|
|||
Replacing front outer CV Boot 1999 E320
Hello,
I"m going to replace the left front cv boot on our 1999 E320 4matic wagon. I don't have any service manual's so I thought I would ask if anyone has a sequence on this job. On our 1992 300te i was able to remove the axle nut and turn the tire as far as it would go and slip out the axle. I'm not sure if the axle just pulls out of the transaxle or is the something else. Also, is there an inner clip on the outer cv joint to remove the joint. Thanks, Steve 1999 E320 $matic Wagon 1992 300TE $matic Wagon (For Sale) 1979 Porsche 911SC Last edited by stevenatale; 09-14-2006 at 07:22 PM. |
#2
|
||||
|
||||
hope you like axle grease.
I've done this a dozen or so times, but exact procedure slips my mind at the moment. there isn't a clip inside, just pull once you get the axle out. getting the end of the axle off can be difficult too, almost to the point where it seems like you're doing something wrong. it will however eventualy come off. I can't recall but the caliper may have to come off and an upper nut(?) may have to be removed as well to let you swing the end of the axle out of the hub. once the axle is loose from the hub, remove the lower shock bolt and pry down on the lower control arm against the subframe, unless you would rather remove the whole arm which would make it easier to get the axle out, but more work overall, plus alignment.
__________________
1980 500SE/AMG Euro 1981 500SEL Euro 1982 380SEL 1983 300TD 1983 500SEC/AMG Euro 1984 500SEC 1984 300TD Euro 1986 190E 2.3-16 1986 190E 2.3 1987 300D 1997 C36 AMG 2003 C320T 4matic past: 1969 280SE 4.5 | 1978 240D | 1978 300D | 1981 300SD | 1981 300SD | 1982 300CD | 1983 300CD | 1983 300SD | 1983 380SEC | 1984 300D | 1984 300D | 1984 300TD | 1984 500SEL | 1984 300SD | 1985 300D | 1986 300E | 1986 560SEL | 1986 560SEL/Carat | 1987 560SEC | 1991 300D 2.5 | 2006 R350 |
Bookmarks |
|
|