|
|
|
#1
|
|||
|
|||
I had the system recharged last week and it was working good up till now. Now the compressor won't engage when the system is turned on. I jumpered the low freon switch with no result. Fuse is ok. Where is the relay located for the system? Any ideas? Thanks Dan
1980 300D 225500 miles |
#2
|
|||
|
|||
Be sure to check power on both side of the fuse!. I had the same problem and found the fuse connection not making good contact in the holder and it caused the same problem of no clutch engaugement. I think your 300D has the temp control thermostat knob on the console. Check to see if there is power at the switch after checking the fuse. I think also the power is distributed by the vacuum relay switch as well so check to see if the a/c heat is switches over properly. Someone please correct me if I am wrong!
Regards, Bryan |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
300TD Air Conditioning Problems | flbiggs | Diesel Discussion | 10 | 08-17-2007 07:20 PM |
W210 Air Conditioning System Fault Codes | JimSmith | Tech Help | 15 | 01-20-2005 11:38 PM |
Air Conditioning Problems | very tired | Tech Help | 1 | 07-29-2003 07:53 AM |
300D Turbo Air Conditioning | jconley | Diesel Discussion | 2 | 05-11-2003 04:36 PM |
300d air conditioning | xjustinx | Tech Help | 1 | 04-08-2002 07:37 PM |