Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 02-07-2007, 07:40 AM
Registered User
 
Join Date: Dec 2006
Location: Alpharetta GA
Posts: 74
I have an 89 560sel that is doing the same thing. I have been chasing it for a couple months now. Tom
Reply With Quote
  #2  
Old 02-07-2007, 09:33 AM
david s poole
 
Join Date: Mar 2005
Location: dallas
Posts: 1,822
there is an idle control relay hidden behind the glove box with the fuel pump relay.you will need to remove glove box and panel underneath it to access but probably the problem.
__________________
David S Poole
European Performance
Dallas, TX
4696880422

"Fortune favors the prepared mind"
1987 Mercedes Benz 420SEL
1988 Mercedes Benz 300TE (With new evaporator)
2000 Mercedes Benz C280
http://www.w108.org/gallery/albums/A...1159.thumb.jpg
Reply With Quote
  #3  
Old 02-07-2007, 09:35 AM
david s poole
 
Join Date: Mar 2005
Location: dallas
Posts: 1,822
the relay for the sel is behind the angled panel on the floor where passengers feet go.
__________________
David S Poole
European Performance
Dallas, TX
4696880422

"Fortune favors the prepared mind"
1987 Mercedes Benz 420SEL
1988 Mercedes Benz 300TE (With new evaporator)
2000 Mercedes Benz C280
http://www.w108.org/gallery/albums/A...1159.thumb.jpg
Reply With Quote
  #4  
Old 02-07-2007, 08:18 PM
Registered User
 
Join Date: Dec 2006
Location: Alpharetta GA
Posts: 74
David, Thanks for the tip. I will check it out and see if that helps.Do I dare ask what this relay looks like with out sounding too dumb? Thanks again Tom
Reply With Quote
  #5  
Old 02-07-2007, 09:29 PM
Registered User
 
Join Date: Dec 2006
Location: Alpharetta GA
Posts: 74
MTUpower, Thanks for the info. Sorry I didnt say I had the 89 560sel.So mine should be in the pass. foot well.... Yes I checked and cleand the ICV and rubber boots. I want to say when I unplug the ICV the idle goes UP from 1000rpm to say 13 or 1400rpm. Tom 89 560sel.
Reply With Quote
  #6  
Old 02-07-2007, 09:56 PM
Registered User
 
Join Date: Jul 2004
Posts: 7,415
You can always check the throttle linkage. Remove the air cleaner and have a friend pump the gas pedal- you'll see the linkage moving. In the front there is a section that goes straight down. Take a 8 mm wrench and put it between the two linkages and twist- the lower one will then pop off- do the same to the bottom and then you have a short linkage section about 4 inches long. If you hold the end with pliers you can take the 8mm wrench and spin the lock nut down and then rotate the ball end. Making the whole section shorter will decrease the idle- making it longer will increase the idle. It only does so much- as the other controls will come into play. Idle is also a part of the fuel mixture. with the air cleaner off you can see the fuel distributor- which is what the air cleaner sits on. In the front of it is the mixture control- it's a 4.5mm allen wrench adjustment. Put the allen wrench into the hole and press down- it's spring loaded. By twisting either direction slowly you adjust fuel/air ratio I believe. This effects idle. So now you have about 5 different systems affecting idle. Oh- also is the warm up control- which is right next to the idle control valve. Tap on it a few times. It's designed to raise the idle just a bit when the engine is cold. While doing anthing tot he car be sure you know where you started with every change you make so you can set it back to where you started. YTou dont want to change a bunch of stuff and not be able to get back to the staring point- yo could really mess up how the engine runs and then you gotta spend alot of time or alot of $ to a pro to fix your F*&^up.
Reply With Quote
  #7  
Old 07-10-2007, 04:11 PM
Registered User
 
Join Date: Jul 2007
Posts: 3
Quote:
Originally Posted by MTUpower View Post
The idle control box is next to the windshield washers, on the window side of the firewall, right on top- it's a black rectangular box that holds circuits inside.
Unable to find, can you clarify which winshield washer or do you mean wipers?

TIA

Wayne
'88 560sl Black
Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 01:05 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page