|
|
|
#1
|
|||
|
|||
Mount Torque
Engine Mount 87 560SEL, manuel says 70NM which is about 90ft lbs, way too high I would think.
Anyone Know?? John1 |
#2
|
||||
|
||||
Not sure what conversion factor you are using but you might find you do better w/
1Nm = 0.737561 ft/lbs. Jonathan
__________________
Blue Ridge Mercedes Jonathan Hodgman http://www.blueridgemb.com/ Enthusiast Service, Restoration & Tuning. Follow Us on Facebook! Located in the Atlanta area Specializing in all pre and post merger AMG's including Hammers and DOHC M117 engines. Mercedes Repair Atlanta |
#3
|
||||
|
||||
As an aside, I hope you have genuine mounts...if not plan on doing them again in the next year or two.
Jonathan
__________________
Blue Ridge Mercedes Jonathan Hodgman http://www.blueridgemb.com/ Enthusiast Service, Restoration & Tuning. Follow Us on Facebook! Located in the Atlanta area Specializing in all pre and post merger AMG's including Hammers and DOHC M117 engines. Mercedes Repair Atlanta |
#4
|
|||
|
|||
In other words you converted the wrong way - should be 52 ft. lbs.
|
#5
|
|||
|
|||
Thanks alot, I did in fact convert the wrong way and did torque to about 70 ft lbs, did not strip, will leave them at that and thank God!
John1 |
Bookmarks |
|
|