|
|
|
#1
|
|||
|
|||
1995 W140 dtcs
I have the following DTC codes on my 1995 S500
E006 E074 E075 E082 E083 E086 E102 E103 E106 E107 I have the following symptoms: No a/c hot air all of the time aux fans don't seem to come on blower motor regulator was replaced but blower still does not work. Please help! I do not know where to begin. |
#2
|
|||
|
|||
006 - connection to switchover block valve - this is the gizmo up behind the glove box with about a dozen vacuum lines connected to it - it controls the vacuum flow to all the duct damper actuators.
0074/75/82/83/86 - problems with the duovalve unit for the heater - up under the hood, driver's side on the fender behind the headlamp. 0102/103/106/107 - problems with the 2nd and 3rd stage fan activations. Code 74 & 75 are the same problem, with 74 being a permanent failure and 75 intermittent. Same with 82 (perm) and 83 (int). 86 is a permanent failure. Same deal with 102 (perm), 103 (int) for 2nd stage fan activation. 106 (perm) and 107 (int) is for 3rd stage fan activation. Before I'd spend a single dime on parts, I'd check the A/C control unit in the dash. Contact the folks at Programa in FL (www.programainc.com), they may be able to test it for you for a small fee. I replaced my duovalve unit (about $400 if I remember at wholesale prices) before having my control rebuilt, and I wonder to this day if that wasn't money wasted. The controller will report all sorts of problems that it can cause on it's own. Possibly the 006 error is because it can't communicate with the switchover block valve, but that could be because the controller is toast in that area, or the block itself is bad. |
#3
|
|||
|
|||
the combination of fault as you indicate is all directed at the climate control unit, your car is most likely equipt with the first generation control module which was found to have software defects, an upgraded version is available and made by kramer and not bosch.
|
#4
|
|||
|
|||
Got my "repaired" climate control unit back from Programma today
I still show all of the same dtc error codes and have the same problems.
HELP! |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|