![]() |
|
|
|
|
#1
|
|||
|
|||
my 1991 mercedes 300 e shuts downs afther a while
hello i need some help, my mercedes shuts down after running for about 10 minutes and then the battery is kind of deat. then i jump start and it runs again til it shuts down again. please any help.. thank you
|
#2
|
||||
|
||||
![]() Quote:
![]() |
#3
|
|||
|
|||
the battery is new, and when i disconect the battery when the car is running it keeps running with the lights on and the air condition, for like about 10 minutes and then it shuts down by it self.
|
#4
|
||||
|
||||
I think that your problem is an electrical issue. But I don't know how to solve it. A question may be helpful. Did you try to change the battery again? (Even if it is new).
__________________
Master Computer Engineer, A+, Network+, MCP/MCSA/MCSE 4/2k/2k3 - Messaging, MCTS, MCITP, MCT, Brainbench, ICDL and starting Ph.D 380SE 1984 <------- Totaled by flipping accident 300SE 1988 <------- Sold Volvo S70 2000 <---- 4 family Opel Omega 2002 <-- 4 family 560SEC 1989 <------ Sold 560SEL 1990 <------ Sold 560SEL 1991 <------ 4 my mother 560SEL 1989 <------ Sold 600SEL 1992 <------ Current |
#5
|
|||
|
|||
Please do not disconnect the battery while the engine is running.
Is there a reason for you doing this? Also it will be helpful if you explain in detail what happens when the problem occurs. 1. Make sure the battery connections are clean and tight. 2. Charge the battery, slow, low amp charge is best. Battery should have over 12 volts at this point. 3. start the engine, check voltage at battery, should be about 13 to 14.5 volts. 4. If voltage with engine running does not increase, the problem is either a worn out voltage regulator (on the back of the alternator) or worn out alternator. This is assuming that all the electrical connections are good. 5. If the voltage increased properly with the engine running, you should have the battery properly load tested and the cells checked as mentioned in above post. PS. I think you may also need to check for excesive current draw. Good luck, Acky |
#6
|
|||
|
|||
I was driving on the higway when first the SRS light when on then the sbs. 10 to 15 minutes later the head lights loose claritiy and the interior lights of the panel when off, the engine died and when i tried to start it the battery had little bit power. i hope this can help but for now i'll check the battery and alternator voltage. thankx
|
#7
|
|||
|
|||
Check the voltage regulator, I'm betting your brushes are worn. You can replace just the brushes, but it's better to replace the whole regulator as it's pretty inexpensive.
__________________
08 W251 R350 97 W210 E320 91 W124 300E 86 W126 560SEL 85 W126 380SE Silver 85 W126 380SE Cranberry 79 W123 250 78 W123 280E 75 W114 280 |
#8
|
|||
|
|||
Ovp
Hello -
You just described what I had fixed at the garage this week: ABS- SRS lights and the engine would cut out or not restart. The mech replaced the OVP. |
#9
|
|||
|
|||
could you please describe better what's the ovp? thankx
|
#10
|
|||
|
|||
Over Voltage Protection Relay
It helps to maintain components from getting too much juice. Apparently, mine had a crack in the solder. When it was tapped, the problems would come or go away.
Since it was R & R'd, there are no longer problems with cold start, ABS, SRS lights,... It is most probably on the ABS or fuel pump circuit- havent researched that yet. |
#11
|
|||
|
|||
and how it can be fixed? do i have to change some parts? thankx
|
![]() |
Bookmarks |
|
|