![]() |
|
|
|
#1
|
|||
|
|||
1997-E320 Hesitation and Backfires
Hello,
I have some issues on 1997-E320. When I start the car in the morning doesn't take acceleration & backfires a lot. I have to accelerate very slowly at low RPM or the car would hesitate and backfires. I did change new spark plugs and spark plug wires,Transmission fluid was replaced with new oil filter (sometime in high speed does not respond fast hesitate ). But still same issues,the engine light does not came on and the car has 156K miles. I just got the car,no any records in the car. What can be AMM??? OR ??? ![]() If is AMM is there any way to test it ??? Any good thread about AMM ??? ![]() Thanks Guys. ![]() |
#2
|
|||
|
|||
Do a search, as your identical symptoms have been discussed before. Most likely cause is AMM. You can try cleaning it and/or replacing it.
__________________
08 W251 R350 97 W210 E320 91 W124 300E 86 W126 560SEL 85 W126 380SE Silver 85 W126 380SE Cranberry 79 W123 250 78 W123 280E 75 W114 280 |
#3
|
|||
|
|||
yes yes, CLEAN it first. However, if it's original, it's probably toast. $300ish to replace from Phil. Try a can of CRC Mass Air Flow Sensor CLeaner, $5 from autozone, etc
__________________
former: 83 300D, 97 C230, 93 400E current: 08 C300 Luxury , 92 500SL |
#4
|
|||
|
|||
I cleaned mine and it worked great for about a week before acting up. I cleaned it again with no improvement. Same flat spot, would hesitate and stall unless I accelerated either very slowly or very aggressively. I keep the old one in the trunk as a backup in case of total failure - it may not work great, but it does still work.
__________________
08 W251 R350 97 W210 E320 91 W124 300E 86 W126 560SEL 85 W126 380SE Silver 85 W126 380SE Cranberry 79 W123 250 78 W123 280E 75 W114 280 |
#5
|
|||
|
|||
<>
Did you use Plats ?????????? |
#6
|
|||
|
|||
I did not use Platinum plugs don't like them,I used regular Bosch plugs.
I tried to clean AMM like the guy said but it worked for a week or so and again same problems. What you guys think about AMM from Germanstar.net they are selling for $129.00? Is this is a waste of money or better to go for original Bosch or Mbz Parts? Thanks. |
#7
|
|||
|
|||
What plug # did you use..
They have to be F8DC4 for 104 engine. NON- resistor |
#8
|
|||
|
|||
Yes I did use Bosch #F8DC4,but today I got new AMM and working like new again.
![]() Transmission shift much smother too. ![]() Thanks one more time for support. ![]() |
![]() |
Bookmarks |
|
|