|
|
|
#1
|
||||
|
||||
check engine light...?
91 300SE check engine light on the dash is on....car seems to run fine...no leaks...no strange noises...how do I read the fault codes and such? can I shut it off with a special tool.??
Last edited by Lead; 08-02-2007 at 03:12 PM. |
#2
|
|||
|
|||
See posts 2 & 3 and build Arthur Daltons code reader.http://www.peachparts.com/shopforum/showthread.php?t=107630
Post back with results.
__________________
Terry Allison N. Calif. & Boca Chica, Panama 09' E320 Bluetec 77k (USA) 09' Hyundai Santa Fe Diesel 48k (S.A.) |
#3
|
||||
|
||||
Ok kool...thanks for the info...I understand now!
|
#4
|
|||
|
|||
That's a nice thread but the fault code list does not apply to your car. A 91 126 body has less sophisticated code reading. Your diagnostic connector may be an 8 pin rather than 16 pin, but the code reader should still work.
|
#5
|
||||
|
||||
yes mine looks like a (8) pin connector...with a little black button you can depress....(California car)....does that button used to reset the light/reade code?? my #2 pin is the black button, #4 pin is a red LED, when i press it it lights up red until i release the button.
Last edited by Lead; 08-02-2007 at 07:04 PM. |
#6
|
||||
|
||||
Inspected the engine bay over the weekend more carefully...Looks like it could have been a loose vacum hose...I reattached the offending hose...reset the check engine light by disconnecting the battery for few minutes... its been 2-days now...so far no CEL rtn...Thanks again gents!
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|