|
|
|
|
|
#2
10-06-2001, 07:10 PM
|
|||
|
|||
|
The larger heat sheilds (seals) are a replacement for the early ones that went into the hole. Remove the old ones and just install the new ones. It makes removal of the early ones easier if you use a tapered punch to "rock" them back and forth. Try to find something close to the right diameter so it doesn't go through too far and knock the diffuser ball loose in the pre-chamber.
Regards, Randy D. 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rings and bearings type rebuild?? | JDmills | Diesel Discussion | 7 | 01-23-2005 11:10 AM |
| O Rings on oil filter stem...question | Vladamir | Diesel Discussion | 15 | 12-18-2004 05:14 PM |
| 240D rings, sleeves; switching engines 300D | Zane Reese | Diesel Discussion | 3 | 12-02-2002 09:57 AM |
| What are the correct o rings for the R4 at the lower manifold and compressor. | sainttammany | Tech Help | 2 | 08-31-2002 01:05 PM |
| Diesel Engine Break-in Mileage | Mercedes Man | Diesel Discussion | 10 | 03-21-2002 11:57 PM |
Threaded Mode
