I've been trying to test the wiring between the connector for the electronic throttle (X1) and the connector for the EA module (N4/1) before I rip out the throttle and start repairs on it. Alldata's test procedures and wire diagram both show pin 2.12 of the N4/1 connector going to pin 9 on X1 and that this is a voltage supply for the throttle. pin 9 has no contacts on either male of female end of the connector. I also checked continuity on every single contact on X1, none of them make contact with pin 2.12.

I am completely lost and kind of upset that the diagram doesnt match the car at all.