|
|
|
|
|
#1
04-01-2009, 04:39 PM
|
|||
|
|||
|
How do you retrieve error codes on pre OBDII cars?
Alright, I got this 1991 190E 2.6 on the straight and narrow again with the exception of a check engine light. My guess is that with 108K miles and a 60K service interval it is likely an O2 sensor. How the feck do I figure this out with out the use of the old school diagnostic tool or am I out of luck?
__________________
1981 300TD 2005 C55 2004 E500 1999 ML430 1992 400E 1998 C43 2001 SL500 1988 300SEL 1986 190E 16V 1991 190E 2.6 Last edited by Douge; 04-01-2009 at 04:48 PM. 
|
|
#3
04-01-2009, 04:48 PM
|
|||
|
|||
|
Quote:
__________________
1981 300TD 2005 C55 2004 E500 1999 ML430 1992 400E 1998 C43 2001 SL500 1988 300SEL 1986 190E 16V 1991 190E 2.6
|
|
#4
04-01-2009, 06:25 PM
|
|||
|
|||
|
Yes, big changes over the life of the 190E, from virtually nothing to at least something towards the end. Not sure if you have an 8 pin or 16 pin diagnostic connector but you just need to build the code reader and pull the codes from pin 3. Post 3 here - http://www.peachparts.com/shopforum/showthread.php?t=107630 for building the code reader. You need the CIS 103 motor code list.
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
