|
|
|
#1
|
|||
|
|||
Replacing vaccum on '91 300CE
I'm in the middle of replacing the vaccum pods on my '91 300CE. I've got the dash out, and the center counsole. I still can't get to the back screws to replace the diverter pod (which is the one that's bad). Do I need to remove the box to do the job? If so, I can't find it on my cds. Any advice?
|
#2
|
||||
|
||||
There was an extensive tutorial with photos done for this, was on the Diesel forum, now I believe it is in the DIY section.
__________________
Gone to the dark side - Jeff |
#3
|
|||
|
|||
I saw that. It was for the replacing of an evaporator. Would it be the same for the vaccum pods?
|
#4
|
|||
|
|||
Do I need to pull the evaporator if I'm only doing the vaccum pods?
|
#5
|
|||
|
|||
I take it that since I got no reply that its a dumb question and the answer is, "Yes. The evaporator does come out." So here's my next question, thinking I wouldn't have to fool with the evaporator I didn't evacuate the system. Now how to I do that? All I have is a Migty Vac. Do I get someone to come to my house since I can't drive the car out of the garage?
Thanks |
Bookmarks |
|
|