|
|
|
|
|
|
|
|
#1
|
|||
|
|||
|
Replies
Thanks for the fast replies, guys.........
The chain was replaced less than 1k miles ago. I would not know what the compression is without taking the car to a mech. I suspect that it has been quite some time since the valves were checked last, however, this should have been completed when the chain was replaced?. Current oil is fresh Castrol 10/30. North GA climate this time of year is upper 50's for highs and lower 30's for lows, typically. |
![]() |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Inconsistent cold start behavior, 300E | DavidB29 | Tech Help | 23 | 03-06-2007 08:44 PM |
| 300E cold start question | schumi | Tech Help | 0 | 10-13-2003 12:22 PM |
| No Start When Cold | McRoth | Diesel Discussion | 13 | 12-25-2002 10:46 PM |
| Problems to start engine when hot. No problem when cold (below 80 degrees C) | pfgjerpe | Tech Help | 7 | 09-16-2002 11:02 AM |
| '87 300E cold start up integrator duty cycle? | DieselGuy | Tech Help | 0 | 12-30-2001 03:11 PM |