|
|
|
|
|
#1
11-07-2009, 07:02 PM
|
|||
|
|||
|
Trouble starting...
my 1993 300E today. Parked since yesterday afternoon. Went to start a while ago, and it would not start, turned over fine, but stumbled/stuttered. Pressed throttle to the floor, it started and ran. Tried again, stumbled/stuttered. Pressed throttle again, started fine and ran well. Just tried again, started perfectly. Given the original symptoms, is a component getting ready to fail, if so what one could it be. Also, last night temp went down to 27/28 degrees, yet today temp was in low 60's. This car needs to be trustworthy for my daughter and wife to drive. Many thanks! Dennis
__________________
....just drive'em! '89 300TE White w/Blue, 152K SOLD! '93 300E Blue w/Tan, 154K SOLD! '01 E-320 4-Matic wagon, 130K '67 Vette Conv. White w/Blue, 217,421K 
|
|
#2
11-08-2009, 10:23 AM
|
|||
|
|||
|
I wonder if MB has interprets a WOT at start-up as a "clear flood" signal like GM cars do...
__________________
A.S.E Tech A1,A6,A7,A8 & MVAC 609 + EPA 608 Unless stated otherwise, any question I ask is about my greymarket 1985 380SEL. 
|
|
#3
11-08-2009, 11:49 AM
|
|||
|
|||
|
Just went to start the car, NO problem, started normally, but the air temp was 63/64 degrees. I think I'll keep the car in my hands for a couple of days and see if it happens again. In the mean time, if anyone has some thoughts, please share them.
 Dennis
__________________
....just drive'em! '89 300TE White w/Blue, 152K SOLD! '93 300E Blue w/Tan, 154K SOLD! '01 E-320 4-Matic wagon, 130K '67 Vette Conv. White w/Blue, 217,421K
|
|
#4
11-08-2009, 12:38 PM
|
|||
|
|||
|
Sounds like a problem with either the cold-start system or the temp sensor.
__________________
A.S.E Tech A1,A6,A7,A8 & MVAC 609 + EPA 608 Unless stated otherwise, any question I ask is about my greymarket 1985 380SEL.
Last edited by dhjenkins; 11-08-2009 at 01:15 PM.
|
 |
| Bookmarks |
|
|
Linear Mode
