|
|
|
|
|
|
|
|
#1
|
|||
|
|||
|
great lots of help.
Ed, after i get it started the car seems to run fine. the idle is a little rough but its not shaking or sputtering badly. can some one link me a pic of the OVP just to make sue im not being a dumb a**. and looking at soimething that is incorrect. Note: the gas guage is bouncing back and forth. ( i hit the dash and it does not move just everyonce in a while... at all levels of gas) do you think this would cause the start problem? thanks again |
|
#2
|
|||
|
|||
|
Quote:
Ed in Va. |
|
#3
|
||||
|
||||
|
Take off the Air Housing Assembly. First take off the cover that exposes the air filter, then take off the bottom half by unscrewing the 3 retaining screws and slide/lift the assembly out of the air intake and up and off. You'll see the EHA Valve (Black) on the backside of the fuel distributor(aluminum like colored tubes) towards the firewall. I took mine off this morning and made the 1/4" adjustment with a 2mm hex (take out set screw, be careful, it turns very easy and you may not realize you are turning it). It started up much easier after that and idles better.
|
![]() |
| Bookmarks |
|
|