After posting all kinds of threads on different parts I will sum it up.

1985 500 SEL 124,00 miles. Engine ran great and trans shifted well.

I wll keep this vehicle and pass it on to my sons as this was my sisters who died from pancreatic cancer a few years ago. I want this mercedes restored to last.

The car has been sitting for 2 years as it had a very bad trans leak. Before this it sat(garaged) for 2 years. All rubber was dry rotted.

I have:
Completely rebuilt front suspension( not installed yet), brakes, steering gear box (and yes I lost my balls) and have decided now since I have removed the transmission and it is disassembled (722.3) I will pull the engine today (why not there is nothing but a few connections holding it in and will be easier on engine stand.

OBW all hose and any rubber has been replaced along with shocks and new brake lines.

Timing chain, guide, pins and gaskets will be replaced with tensioner and cam oilers. All injector, and required holders /seal will be replaced, distributer cap/rotor/wire/plugs also. Water pump and thermostat are coroded from sitting and using the green antifreeze and will replace radiator and use the Zerox G-05.

The cooling mono valve/hoses etc have been replaced. driveline flex discs and center support also.


The transmission looks very good except for the rear thrust washer was completely shot. Reverse clutches almost gone. However I am rebuilding all trans with master rebuild less steels and probably use the same covertor(flushed) as the trans was so clean.

Any ideas on flushing the engine well when it is on a stand. Also would you replace the reaction vales B1 and B2.
Yes K1 spring kit.

ANY AND ALL SUGGESTION WHILE THE TRANS AND ENGINE ARE OUT??? PLEASE

I will attach photos soon!


Thanks and as always
God Bless
John1