|
|
|
|
|
#1
01-15-2002, 01:15 PM
|
|||
|
|||
stiffness of the rear subframe mounts?
hello gang,
Was looking at my rear suspension parts when I had the wheel off for some inspection and noticed that when I put a prybar between the subframe and chassie the rear mounts only flex a few mm but when I do the same on the ones mounted in the front of the subframe they flex a good 10-15 mm without using a lot of force on the prybar. Aren't they supposed to be equal in elasticity? I took some mental notes when I was digging around there and I reckon I can replace them by lowering the subframe about 3-4 inches in front and pressing the mounts out. Does that sound reasonable?
__________________
/Per MB E300TDT -98 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ? 500E rear subframe in W124 wagon ? | ke6dcj | Mercedes-Benz Performance Paddock | 5 | 11-20-2003 08:20 AM |
| Subframe Mounts 123 | AMH | Tech Help | 0 | 08-30-2003 11:34 PM |
| Question about rear subframe bushing kit | Diesel 924 | Diesel Discussion | 8 | 08-14-2003 09:49 PM |
| 87 300D rear subframe bushings | psfred | Diesel Discussion | 2 | 06-08-2003 05:48 PM |
| Subframe mounts - which is left side? | md21722 | Tech Help | 2 | 10-08-2002 01:06 PM |
Threaded Mode
