|
|
|
|
|
|
#1
|
|||
|
|||
|
Central Vacuum Locking System - W140
My '92 300SD (W140) appears to have a problem with the central locking system. The fuse box in the trunk, circuit 11 has a blown 20 A fuse. I replaced it and it immediately blew again. This circuit is for the central locking system and misc lighting.
Is it possible that a short circuit is now causing the fuse to blow or is it more likely that the central locking system pump is locked and over amping the circuit.? Before I buy a new pump (if needed) and I dissect the car in search of the culprit, I thought I would ask the experience of the forum. If inspection is required of the pump, which I believe is located under the back rear seat, I could use some advice on the rear seat removal as this seat is fastened to the body in a different manner then the usual two clips located at the base of the seat. A checkout procedure etc. would be greatly appreciated. Thanks, Sail42 1992 300SD/500SD - 95K 1994 S350 - 92K Previously owned 1987 300D - 225K 1985 300D - 387K 1979 450SEL 225K |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Disable Central Locking System | 77280E | Vintage Mercedes Forum | 12 | 04-18-2007 01:15 AM |
| Central Locking Vacuum Pump: Repairable? | EricSilver | Tech Help | 7 | 11-07-2003 10:05 PM |
| Central Locking System Vacuum Pump | kiato4 | Tech Help | 2 | 09-30-2003 02:15 AM |
| "Rubber-thing" on actuator for central locking system | emilo | Tech Help | 4 | 04-24-2003 10:06 AM |
| '82 300SD Central Locking System Pump | SW | Diesel Discussion | 3 | 08-08-2001 02:46 PM |