|
|
|
|
|
|
|
#1
02-19-2002, 07:10 AM
|
|||
|
|||
|
One more thing: If you use the c-clip type link, take a look at the c-clip. Usually one side will have rounded edges and one side sharp. Put the sharp edges to the outside. This will give you just a touch more metal to metal surface where it is needed most.
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| timing chain and ip timing question | kmaysob | Diesel Discussion | 3 | 12-14-2004 08:00 PM |
| Help! Timing chain question!! 617 turbo | rwthomas1 | Diesel Discussion | 11 | 11-23-2004 10:47 PM |
| Timing chain question | oilslick | Diesel Discussion | 2 | 10-27-2004 09:02 PM |
| Can I put the master link in the chain before assembly? | Meza | Tech Help | 6 | 06-08-2003 09:58 PM |
| timing chain - crimped versus master link | engatwork | Tech Help | 18 | 04-06-2001 04:50 PM |
Hybrid Mode
