|
|
|
#1
|
|||
|
|||
Rod bearing interchange M120 to M103 / M104 ?
Anyone know if connecting rod bearings interchange between the V12 M120 and inline 6 M103 / M104? The V12 is a variant of the inline 6 so I'd think they would interchange.
I've found some aftermarket part numbers but they are for full sets, if the bearings are sold by the pair that part number would be helpful. Thanks |
#2
|
|||
|
|||
I'd be very hesitant to buy a set of bearings outright. Mercedes has several sizes of "standard" bearings, without getting into "oversize" or "undersize" bearings. To build a bottom end right you need to measure each journal for the proper spec bearing. Easiest way to do that is order 1 pair of +-0 shells and use them to plasti-gauge each journal. Depending on the clearances you measure you then order the proper + or - shells as needed. Hopefully 1 journal can use the +-0 so the shells you bought to measure won't go to waste.
__________________
90 300TE 4-M Turbo 103, T3/T04E 50 trim T04B cover .60 AR Stage 3 turbine .63 AR A2W I/C, 40 LB/HR MS2E, 60-2 Direct Coil Control 3" Exh, AEM W/B O2 Underdrive Alt. and P/S Pulleys, Vented Rear Discs, .034 Booster. 3.07 diffs 1st Gear Start 90 300CE 104.980 Milled & ported head, 10.3:1 compression 197° intake cam w/20° advancer Tuned CIS ECU 4° ignition advance PCS TCM2000, built 722.6 600W networked suction fan Sportline sway bars V8 rear subframe, Quaife ATB 3.06 diff |
Bookmarks |
|
|