|
|
|
#1
|
|||
|
|||
CEL WILL NOT ILLUMINATE or COMMUNICATE
1996 E320 CEL will not illuminate. When scanner is plugged in, there is no communication between the vehicle and the scanner. I also notice that the cruise control does not work, and the car idles really high...up to 1200 RPM. I have checked all the vacuum and I don't see any problem. I have replaced the crankshaft sensor, and many other related parts. I do not want to continue replacing stuff until I am able to scan for codes. I will appreciate any help.
|
#2
|
||||
|
||||
most scanners need a adapter to use the port in engine area.You might try cleaning your Mass air flow sensor.
__________________
1999 w140, quit voting to old, and to old to fight, a god damned veteran Last edited by oldsinner111; 09-01-2013 at 07:15 AM. |
#3
|
||||
|
||||
Check fuses on passenger side by modules in engine bay. I had somewhat same problem on my 98 E320 scanner would't communicate the fuse was blown but CEL would light up. Hope this helps you out.
__________________
1995 E320 1998 E320 1999 E320 4Matic 2000 E320 4Matic 2000 ML320 2007 C230 Sport 2003 Cadillac CTS |
#4
|
|||
|
|||
Take a pic with your fone of the OBDii port up under the dash and compare pin locations to your scanners plug, guessing they are not the same.......
__________________
Terry Allison N. Calif. & Boca Chica, Panama 09' E320 Bluetec 77k (USA) 09' Hyundai Santa Fe Diesel 48k (S.A.) |
#5
|
||||
|
||||
I was using a Snap On code reader it hook to the under dash port,and gave me make,model and vin.I had to connect under hood to clear codes.
|
#6
|
|||
|
|||
Thanks guys for your advice. I am actually planning on buying a new MAF sensor, and see if it will solve the problem. I have not check the fuse on the pass side yet, but I will. I will be sure to post the results. By the way oldsinner11, where can I get the Snap On code reader from?
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|