|
|
|
|
|
#1
04-15-2002, 04:43 PM
|
||||
|
||||
|
seat belt problems in 500E
Hey, i was wondering if anyone knew anything about a W124's seat belt system? I hear the belt runs all the way around the car. At any rate, my SRS light came on, and i took it to get diagnosed, and it came up with "Will need drivers seat belt buckle replaced" Anyone know what the cost is i'm looking at to get it replaced? Are they talking about the buckle or the seat belt strap? Anyone have a clue? Thanks guys!
|
|
#2
04-15-2002, 05:55 PM
|
|||
|
|||
|
The fault code refers to the latch itself. The controller looks to see a 100ohm signal for the latched switch and 400ohms with the switch unlatched. A disconnected switch will be seen as a defect.
The one we replaced on a C280 last week was 75 plus labor.
__________________
Steve Brotherton Continental Imports Gainesville FL Bosch Master, ASE Master, L1 33 years MB technician
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| passenger seat beeps and seat belt light on in dash | 19542743 | Tech Help | 3 | 10-20-2003 10:51 PM |
| Driver's side seat belt replacement S500 | peter210 | Tech Help | 0 | 05-10-2003 07:29 AM |
| '93 300CE CV - Driver seat belt | yambrovich | Tech Help | 2 | 05-03-2003 05:49 PM |
| 86 190E 2.3 - Tach, clock affected by fastening seat belt | DieselGuy | Tech Help | 5 | 01-22-2003 01:51 AM |
| 500E Original Road Test Index <v. long> | Chris W. | Mercedes-Benz Performance Paddock | 10 | 10-09-2001 06:34 PM |
Linear Mode
