|
|
|
#1
|
||||
|
||||
w201 1991 potenchiometer
Hi gang, I am having a search problem with my 2.6, I have tried to get .5 but the best is 0.02 on the 20 volt setting (DC) I have pulled the contact or wipers out just a smidge for a stronger contact but has made no difference. the plate is set at the lower edge of throttle throat, I have a reading of 100 ohms, I am looking for suggestions. thanks JNT: confused:
|
#2
|
|||
|
|||
Be sure your idle is per specifications, then...
SG-Motorsports Air Flow Meter Potentiometer Replacement |
#3
|
||||
|
||||
Quote:
1) Measure voltage between 1 & 2 pins 2) Install Poti's body to get voltage accordingly to diagram. Diagram: x = voltage between 1 & 2 pins y = voltage between 1 & 3 pins blue line = min value green line = max value red line = optimum value So, for example, if you get 5,5 V between 1 & 2 set 0,6 V between 1 & 3. Good luck! |
#4
|
||||
|
||||
And also you may measure current at EHA when installing poti.
It must be from -3 up to +3 mA at +80* C engine coolant temperature. |
Bookmarks |
|
|