|
|
|
#1
|
|||
|
|||
Just wanted someone to conferm that I do in fact have a bad air flow position sensor before I spend 700.00 dollars on the part. As described in the Mercedes Facory Manual, I have tested the resistance across the number one and number three terminals of the air flow position sensor and the resistance is within spec. 3.8 K ohm. But when I test the resistance across the number one terminal and the number two terminal while slowly deflecting the volume air flow sensor plate by hand the values do not increase continuously they start out at about 1.8 k ohms then they jump to about 10Kohms then drops back to about 6 K ohms then the values increase continuously up to about 11k ohms. The values continuously drop after 2/3 travel. The car hesitates while cold in addition at times the idle is high and the cold idle is irractic.
------------------ Babybenz16v |
#2
|
|||
|
|||
The way to check this is to check at pins 1&2 while running. The DC voltage should start out about .6-.8 volts and rise when you deflect or accelerate.
------------------ Benzmac: 1981 280GE SWB 1987 16V ASE CERTIFIED MASTER AUTO TECHNICIAN SERVICE MANAGER FOR 14 BAY FACILITY MERCEDES SPECIALIST 8 YRS PARTNER IN MERCEDESSHOP.COM |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Please, Repair Kit For Air Flow Meter And Fuel Distributor | MARIO FARIAS | Tech Help | 6 | 01-02-2004 09:55 AM |
HELP: air flow meter pot | ThomH | Tech Help | 8 | 12-25-2003 04:07 PM |
Mass air flow ? | rdanz | Diesel Discussion | 1 | 05-06-2003 09:05 AM |
P0100 Mass Air Flow on SLK | yositimy | Tech Help | 1 | 10-22-2002 08:56 PM |
air flow position sensor- 190e 16v > 86 ? | moy | Tech Help | 2 | 04-04-1999 10:55 PM |