|
|
|
#1
|
|||
|
|||
I need to replace the gearshift bushing on my 1990 190 E 2.6 automatic transmission. It seems to be very tight between the trans and tunnel. Is there a trick to make this job easy?
|
#2
|
|||
|
|||
Remove the bolt on the selector lever at the bottom, slide it off the shaft, disconnect the linkage from the upper end and replace your bushing..
------------------ Jeff L 1987 300e 1989 300e 1987 BMW 325 |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
96 C280 Lower Control Arm Bushing Question | Martineau Gauda | Tech Help | 11 | 12-26-2009 07:53 PM |
126/swaybars-booster-no brakes..advice please | gidpor | Tech Help | 23 | 08-11-2005 11:53 PM |
Front control arm bushing compatibility question..??? | J Irwan | Tech Help | 1 | 02-27-2004 01:14 AM |
Upper control arm kingpin (outer) bushing replacement | psfred | Vintage Mercedes Forum | 1 | 02-21-2003 02:56 PM |
500E gear selector rattle | seacoast_benz | Tech Help | 6 | 11-17-2002 03:13 PM |