|
|
|
|
|
#1
06-06-2000, 06:38 PM
|
|||
|
|||
|
After cleaning the intake side of the head I notice oil streaks ( not serious)from what I take are head bolts (torx?). Can these be tightened individually or should the valve cover beee removed and all of them done in sequence.
If so what's the sequence? Is it really a torx bit? ------------------ 1991 350 SDL 114,000 miles [This message has been edited by Chris Haney (edited 06-06-2000).] 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head bolts ...help | Philnguyen | Tech Help | 1 | 03-19-2003 10:12 PM |
| head bolts 190e, 2.3L | Jerry Terrell | Tech Help | 2 | 02-28-2003 04:32 PM |
| W124 rear head rests (long-ish post ...) | za_w124_200e | Tech Help | 0 | 03-24-2002 01:41 PM |
| Head Bolts | jeffsr | Tech Help | 1 | 03-03-2000 03:35 PM |
| Reusing Conn Road Nuts/Cyl Head Bolts | Carrameow | Tech Help | 2 | 10-08-1999 07:50 PM |
Threaded Mode
