|
|
|
|
|
|
|
|
#1
|
||||
|
||||
|
I am chasing a ghost in a 1996 E320. The car has a 300ma draw. When I unplug power plug to passenger front seat module the draw is gone. When I unplug the 4 plugs in the back of the module (they go to the individual seat adjusters) the draw gets less with each 1 removed (until its gone). I replaced the module with a new 1 from Mercedes. And still have the problem. Also if I plug in the power plug with out turning anything on the draw is only 100ma. I had the same problem 2 months ago and the module fixed the problem for about 6 or 7 weeks. What in the seat could be causing a draw? If I unplug the connectors to the motors themselves it changes nothing. Also after I turn on the key or open the door (with the 100ma draw) I get my 300ma back. Has anyone seen anything like this before? Also I need to mention if the car sits for more than 3 days the battery goes dead. But I bet you new that.
Thanks, Mike
__________________
Mike |
|
#2
|
|||
|
|||
|
Dumb question time, are you checking this with the door open? The convience feature setup on this car allows the ESA's to wake up with a open door. Either depress or remove the door switch under the latch catch and look again after the domelamp has timed out.
Joe
__________________
Project Smoker, '87 603 powered wagon Hauler, 96 CTD can you say torque? Toy 73 Cougar xr7 convertible Acme Automotive Inc. Raleigh NC 919-881-0364 |
|
#3
|
||||
|
||||
|
Switches jammed closed I should have mentioned that.
__________________
Mike |
|
#4
|
|||
|
|||
|
I'm assuming the seat works as well.... after the dome lamp has timed out.
if so, send me a e-mail and I'll look into the SI's about the ESA shutting down. Joe
__________________
Project Smoker, '87 603 powered wagon Hauler, 96 CTD can you say torque? Toy 73 Cougar xr7 convertible Acme Automotive Inc. Raleigh NC 919-881-0364 |
![]() |
| Bookmarks |
|
|