Pitman Arm Trouble
Hi-I have a 1985 300TD 123 body. I am trying to remove the pitarm from the steering gear box. I am using a 3 jaw puller with no luck. I don't see any c-clips or pins that would be holding it on. Am I missing something? I do have the bolt removed.
Thanks |
Anyone
Thanks |
Mike,
No help except it requires a powerfully strong puller, our M-B special tool has been ripped in half on more than one occasion. ??perhaps dealer/machine shop/indy might pop it off for a small fee. |
Thanks Paulwho
|
I am not sure about your 123, but 124, 201 steering boxes have a snap ring that gets removed first. I've had no trouble removing the Pitman arm on my high miles 124 using a Snap On Pitman arm remover I borrowed from the mechanic. If you have lots of rust in that area maybe the two parts have bonded together and some penetrant may be needed?
|
I have tried putting WD40 on it with no luck. I was thinking about putting it in the freezer for a couple of hours then heating up the pitman arm and try to pull it.
|
All times are GMT -4. The time now is 10:54 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website