|
|
|
#1
|
|||
|
|||
89' 190e Serpentine Belt Diagram
My serpentine belt snapped on my 1989 190E 2.6L. I purchsed a new belt and after many hours of simply trying to get the tensioner loose I am finally ready to put the new belt on. PROBLEM - how does the new belt go on? I have tried many different setups and read a reapir manual but the manul only shows 5 pulleys yet I have 7 pulleys. Can someone tell me how this belt wraps around these pulleys?
I have: 1-Alternator 2-Pulley 3-Water Pump 4-Power Steering 5-AC 6-Tensioner 7-Crankshaft I can draw out a picture if someone needs to see the setup. Thanks, AKAcalime@akacali.com |
#2
|
||||
|
||||
there are two ways to check it out
if you have an owners manual for the car,the diagram is in there. they are not expensive to buy from the dealer or you could use the search facility of this website-mercedes shop.com and i am sure the diagram has been covered before..- |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|