Thanks a lot for the part #'s and I'm waiting on them now.Meanwhile I realized I threw the question out and didn't get a chance to get the responses before I basically looked at my 560's bolt and found out it was a 17mm bolt.Went to pull a part since I was in the area and got the whole thing for $6 off of another 126 (and all of the rubber,etc was dirty but no tears,etc and bolted right on). If you look at the picture that part was replaced and was still like new but they probably didn't tighten it very well.

I was also able to just turn the wheel and park the car with the front uphill and the rod basically went right where it was supposed to.Of course the rubber wouldn't fit as snug so I slowly jacked her up until everything lined up and she went right in. Then I was able to screw in the bolt and tighten her up some,lower the car and tighten to spec.Took all of about 5-10 minutes. Took her on the highway with no hands and she's as straight as an arrow on the road and no problems. Thanks again for the help.

P.S. That $6 included a few other things like an extra OVP, aux water pump and other goodies I basically got the stuff I NEEDED for free! HEY Mike!

Thanks again guys

Alan

__________________
1997 E320
1986 560SEL
1983 300SD
1972 220D
1970 250C SOLD
1971 250C SOLD