Thanks to Strife and Rich for the replies. This job can be a &^%$*&$#@ if doing it for the first time. Tiny screws, hidden behind rubber flaps in places too small for your fingers. First side took over 3 hours, mostly finding the screws and then fumbling getting them back in. Second side took about 40 minutes. Hope this helps someone else save time. First, on the removal, wedge out the part of the seal next to the window. You just need to get a piece of it and then pull the rest out. Then take a razor knife and slit the rubber flap from the top of the pillar to the bottom. Remove the flap, and the screws are exposed. Remove them and the trim piece comes off along with the remainder of the seal under it. After cleaning everything up, I put a piece of tape adjacent to each screw hole and then marked the exact location of the hole with a pencil line on the tape. Now you know exactly where the screw holes are when you reinstall. Start installation with the part of the seal next to the side window by wedging it into the groves. I used a screwdriver. Position the seal at the top and work down a couple of inches, then do the same at the bottom and work toward the middle. Reason for this is the seal has a tendency to lenghten if you just work fron one side. This part of the seal must be exact at the top and the bottom because of a plastic retainer at the bottom and the need to be precise when you start the seal down the front side under the trim piece. At this point I found it hard to keep the seal properly positioned on the trim. I ended up using small rubber bands to hold the seal on the trim piece. Working from the top to the bottom, the remaining screws must be reattached keeping the seal positioned on the trim piece. Problem here is to are putting tiny screws into a place your fingers don't fit all the while holding back the flap that they fit under. I used Super Glue to hold each screw onto the driver, an ice pick to locate each hole and to hold back the flap and then installed the screws. The key to the whole thing is the Super Glue and knowing exactly where the holes are. (reason for the tape and pencil mark. After the first side, I swore to never do another. After the second side, I don't consider it a hard job at all.