|
<
Glad you found a use for the tool .. very simple to make .
What you want to do is reset the modules memory after you clear the codes. This is done after you get a single flash from 8 and 14 by pressing again for 6 sec. , key off for 10, 0n for 10 and restart. This resets the mean of ECU.
You will not get a single flash on DM [ 3] until the Emissions module has gone through all self test. [few drive cycles]
None of your codes indicate BL sw. but I would chage it anyway if it is orig.
Your suspect is sticking cable.....
|