Pic of My New Boost Gauge Panel

[McRoth]

I saw someone had made a gauge panel like this where the ash tray goes so I thought I'd make one for a boost gauge & 2 12V outlets. It turned out pretty good other than I should've used red oak stain instead of cherry. Also I think the outlets would've been better centered down lower, but all in all I like it! I picked up the gauge from JC Whitney for $12!! It matches the stock gauge cluster almost perfectly. It's showing me that my boost pressure is low, only 7lbs between 3K & 5K, I'm thinking it's the wastgate, but I need to do some searching first.