|
|
|
|
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
05-24-2005, 10:19 PM
|
|||
|
|||
|
Is this vacuum modulator rubber cap correctly installed (722.418 transmission)?
The vacuum modulator dust cover (126 277 00 81) on my car looks like the left picture. I pushed it, but it did not go in further. Is the cover correctly installed, or must it be re-installed so that it looks like the right picture?
__________________
1992 300D 2.5 turbo diesel. 319 k miles. 124.128 chassis, 602.962 engine, 722.418 tranny. 
|
|
#2
05-24-2005, 11:22 PM
|
|||
|
|||
|
cap
the left is correct
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transmission knock, vacuum line?? | WJJ | Diesel Discussion | 1 | 07-28-2004 08:56 AM |
| High vacuum at fuel cap | ricali | Diesel Discussion | 13 | 07-17-2004 06:16 PM |
| transmission vacuum modulator -fluid inside? | rschleicher | Tech Help | 1 | 07-14-2004 10:04 PM |
| I only have 1 vacuum line going to the gas cap... | shawnster | Diesel Discussion | 8 | 11-20-2002 07:42 AM |
| vacuum hose routing to transmission | deeph8 | Tech Help | 3 | 10-23-2001 06:17 PM |
Linear Mode
