|
|
|
#1
|
||||
|
||||
B2 Piston Seal - Which Direction?
I am in the middle of replacing my B2 piston, bushing, seal and cover seal.
The seal that goes into the transmission case atop the bushing, has a flat side and a indented side. To me it looks as though the flat side should face towards the cover, but the one installed in my car was the other way around....the flat side was pressed in facing the case. Which is the right way? Thanks Don
__________________
1980 300TD-T (82 Turbo and Trans) 159,000 Miles "Jackie-O" 1983 300SD 272,000 Miles "Aristotle" 1987 Jeep Wagoneer Limited - keeps the MB's off the ice and out of the snow 1994 BMW 530it |
#2
|
||||
|
||||
Oooops found the answer in the trans manual (I had checked before but could not find it) The flat side faces the case...not the cover.
Thanks Don
__________________
1980 300TD-T (82 Turbo and Trans) 159,000 Miles "Jackie-O" 1983 300SD 272,000 Miles "Aristotle" 1987 Jeep Wagoneer Limited - keeps the MB's off the ice and out of the snow 1994 BMW 530it |
Bookmarks |
|
|