|
|
|
#1
|
||||
|
||||
603 rear crank seal holder needs sealant?
Procedure 01-222 is not clear on where sealant should go when fitting the rear crank seal holder. Says coat parting surface of cap and coat parting surfaces on end cover. Is that the surface that meets the block or oil pan or both?
Thanks, Sixto 93 300SD |
#2
|
|||
|
|||
I don't remember putting any sealant on the body of the rear main seal of my 603.......or that is was required!
Do it anyway, it can't hurt! Last edited by Perkinsguy; 12-05-2006 at 07:09 PM. |
Bookmarks |
|
|