Had to way overtorque tranny drain bolt...

[winmutt]

Torqued to 10lb then starter pouring mobil 1 synth tran fluid in. Started dripping right away. Rechecked torque and retorqued to 15lb. Still leaking. After that I just kep torquing until it stopped dripping. I had noticed with the pan off that there was a decent sized groove aorund the pan at the drain bolt. Can I get a new pan or just over torque? The torque converter was just fine. Used two fresh crush washers on the pan and cleaned it thouroughly. This is 4 bolt pan tranny.