|
|
|
#1
|
|||
|
|||
Anyone know how to change these?
I have 87300TDT and I want to change the bulbs in the CCU. I pulled it out of the dash and I can't see anyway to get at the bulbs short of breaking it up into pieces. There are two bulbs covered over with some kind of foil tape but no way to get hold of them. If I take the cover off there is a circut board covering the bulbs and it dosen't appear to come out. Anyone know how to access them? Is there a secret to this? Any help would be great. Thanks
|
#2
|
||||
|
||||
i have used really small diameter vacuum hose to remove and intall them, you may need to draw vacuum on the hose to keep the old bulb from slipping out, when installing the new bulbs, just insert bulb enough to hold it in place so you don't inadvertantly remove it when removing the hose and twist gently.
usually most smaller emissions type vacuum lines should work.
__________________
1967 250 S 1967 280SE 1968 250S 1971 280 SE 1973 220 1974 280 S 1975 450 SEL 1976 220 D 1979 300SD 1983 300 SD 1985 230 TE euro 1986 280SL 1986 500 SEL euro 1986 190E 2.3 1990 300 SE 2003 C230 K 2004 C230 K 1987 560SEL 1987 300SDL now in canada 2005 C230 1998 C43 AMG Sold to DON 1993 190E 2.6 300TD Former daily driver Totaled current: R320 CDI Ram 2500 Cummins |
#3
|
|||
|
|||
So remove the foil and pull them straight out?
|
#4
|
||||
|
||||
yes, using a piece of small diameter vacuum hose slip it on the bulb and pull out, use the new bulbs to find the correct size hose before you begin
__________________
1967 250 S 1967 280SE 1968 250S 1971 280 SE 1973 220 1974 280 S 1975 450 SEL 1976 220 D 1979 300SD 1983 300 SD 1985 230 TE euro 1986 280SL 1986 500 SEL euro 1986 190E 2.3 1990 300 SE 2003 C230 K 2004 C230 K 1987 560SEL 1987 300SDL now in canada 2005 C230 1998 C43 AMG Sold to DON 1993 190E 2.6 300TD Former daily driver Totaled current: R320 CDI Ram 2500 Cummins |
Bookmarks |
|
|