So I removed the wheels on my 82 300sd today, and repainted the Bundts. Put the wheels back on, and all of a sudden my car pulls hard to the right on the front passenger wheel.

Too dark to see right now, but any common stupid mistake I may have made when doing this? Put all four corners on axle stands, and rotated the tires when they were replaced.

__________________
79 300SD - $50 out of pocket purchase
03 Dodge Ram 3500 CTD
2003 VW Jetta TDI

I'd check the tie rods first. It's pretty easy to lift on the tie rod by accident if you are jacking the car up by the lower control arm.

__________________
"spreading a trail of obnoxious where ever we go"
1981 300sd w/ 341,500 miles

http://www.wecrash.com/pics/ddda_banner.gif

Hmm...I'll check and see, but I don't think I came near the tie rods at all with the axle stands, definately not the jack.

__________________
79 300SD - $50 out of pocket purchase
03 Dodge Ram 3500 CTD
2003 VW Jetta TDI

Stuck caliper?

__________________
83 SD

84 CD

If you don't see anything else, swap the two front tires. I have seen this problem many times. If the problem goes away, you are fine. If the problem moves to the other side, you have a bad tire.

__________________
84 500 SEL (307,xxx miles)

Unrotate your tires first. If you restore the original configuaration all should be the same as it was.

Where do you all place your axle stands when removing all the tires?

__________________
79 300SD - $50 out of pocket purchase
03 Dodge Ram 3500 CTD
2003 VW Jetta TDI

And it is, thanks for all the help.

__________________
79 300SD - $50 out of pocket purchase
03 Dodge Ram 3500 CTD
2003 VW Jetta TDI