Quote:
Originally Posted by jkoebel
I lied, it does have a crush washer. I just didn't see it was its own part because it was so encrusted on.
I took it off, cleaned it up, and its still leaking from there...guess I'll be ordering a new one.
|
or you can anneal it and sand it down
step 1
use a propane torch or a gas fired oven(use the burner) hang it over the heat 2-3 seconds at most..
then let cool so you can handle is ... use a fine grit... (not too fine) and sand both sides
tip) so not to sand down your fingers place the washer between two pieces of sand paper and sand both sides at once.
clean off... and reinstall..
works well... then make a note to pick up a new one for the next filter change