|
|
|
#1
|
|||
|
|||
603 valve cover removal steps 1987 300D
I removed the 10mm hex bolts off of my 603 engine valve cover, but the valve cover won't budge. Should I try prying it with a large blade under the gasket? Any Ideas?
Thanks,
__________________
Springsman Colorado Springs, CO |
#2
|
||||
|
||||
did you remove the cross over tube?
don't pry anything Check along the entire perimeter for any missed bolts. Plus if you did get them all just give it a tap with a hammer( put a block of wood on the face first!) and then it should unseat it self( last resort reallt as it should just pull up and off) |
#3
|
|||
|
|||
yes I removed the intake tube that crosses the cover
Yes I remove that tube.
__________________
Springsman Colorado Springs, CO |
#4
|
||||
|
||||
Tap it with a rubber hammer it will pop free. If you pry it with something be carefull not to mark up the mating surface.
__________________
1999 SL500 1969 280SE 2023 Ram 1500 2007 Tiara 3200 |
Bookmarks |
|
|