|
oil pre-luber
This is an engine pre-luber I picked up off of autoenginelube.com It's a pretty basic design and I'm really excited to get it plumbed in. This is the only mounting position I have been able to find. I'm sure there are more that allow the bottle to be in a perfect vertical position, but this is what I've come up with so far.
A question I have is... are there any other places on the motor that I tap into the oil gallery? I know some motors have a threaded plug that allows you to hook up an oil pressure sensor. Since the OM616 uses a capillary to carry engine oil to the gauge, I'm wondering if such a place on the block exists. The only place I know of is there the capillary feeds into in the oil filter housing. Any feedback would be greatly appreciated. 
__________________
1977 Mercedes 240D... 4 speed manual... soon to be host to a lot of mods..
1984 Toyota 4x4.. Weber 32/36 DGEV carb, Offenhauser Dual Port intake manifold, TRD cam, MSD 6A ignition, MSD 8.5 wires, MSD Blaster coil, NWOR Tri-Y header, cat-back exhaust, NHK 3" lift springs, Black Magic electric fan, LC Engineering crank pulley,traction bars, LockRight locker, oil cooler, manual water temp gauge, oil temp gauge, vacuum gauge, and 394,000 miles on the clock with one motor change.
|
05-28-2008, 12:39 AM
Linear Mode
