I'm needing to remove the head on my 123 300d and i need a star bit to do it. What size do I need or is it a specialty tool. I do not want to strip them if i can avoid it.
I am disassembling the entire engine no this 1984 300d 123 Euro if anyone needs a part. I tried selling the engine and for a long time no takers. Everything on the engine is being removed including the entire block etc. Interior and exterior as well. It's harvest green, all manual interior.
I mostly need to know what I need to remove the head fo now. Thanks Ray M

What you need is a 12 point (triple square) or XZN

part# 601-589-00-10-00 MB part#

I got one from the Matco tool guy. around $20

Charlie

__________________
there were three HP ratings on the OM616...

1) Not much power
2) Even less power
3) Not nearly enough power!! 240D w/auto

Anyone that thinks a 240D is slow drives too fast.

80 240D Naturally Exasperated, 4-Spd 388k DD 150mph spedo 3:58 Diff

We are advised to NOT judge ALL Muslims by the actions of a few lunatics, but we are encouraged to judge ALL gun owners by the actions of a few lunatics. Funny how that works

Thanks I do appreciate your time and help on this. Ray

I got a set of 4 of these bits 6, 8, 10, and 12mm made by Lisle Corp. for $12.00. Lyle is located in Clarinda IA. They call them 12 point, Triple Square and the part # is 60750. They are made in the U.S. and I used the 10mm to remove the head from my 603 motor. I got them from Clark tool here in KC Missouri. Might be cheaper and easier than getting the part from Mercedes.
Good luck,
Brad

Got a set at oriley for 4.99

size M12 from any of the aforementioned sets all called by various names EXCEPT Torx.

autozone and advance usually have a set for $13 that contains this size

__________________