Took a 0-60 video of my 300SD today.... - PeachParts Mercedes-Benz Forum

pawoSD · #1 03-10-2009, 12:56 PM

I was out and about for a while today, so I whipped out the crappy cell phone camera and took a video of my car doing a 0-60. It seems to be about 14ish seconds....however, the test was slightly uphill, and I had junk in the trunk and back seat, 3/4 tank of fuel....and it was raining....so not optimal conditions. I bet I could get a 12.5 to 13 on level ground with all the junk out of my car on a dry day.The white thing behind the wood on my dash is a piece of paper....the wood backing is separated and vibrates (really annoyingly) so the paper stops the vibration.

I'll glue it eventually....

I also have my bowden cable set to shift a bit earlier....

Enjoy the horrible resolution.

http://www.youtube.com/watch?v=DyVk1jRHgXs

Now I just need to take one of our 300E....that'd make this look reeeal slow.

pawoSD · #2 03-10-2009, 01:55 PM

Nobody even viewed it?

Sigh.

ascalise · #3 03-10-2009, 01:58 PM

Your 1st to 2nd shift is way too early.

pawoSD · #4 03-10-2009, 02:08 PM

Quote:

Originally Posted by ascalise

Your 1st to 2nd shift is way too early.

I have it adjusted that way on purpose....so my 0-60 probably isn't optimal.

If I really jam it to the floor (which I don't think I was) it will hold 1st to about 3500-4000.....

oldsinner111 · #5 03-10-2009, 03:31 PM

Looks good.However I manually shift at 4500 when racing.

bgkast · #6 03-10-2009, 03:53 PM

Looks more like 15.5 seconds to me.

Tighten that Bowden cable!

The gauntlet has been thrown, I'll run my SD today and get a video.

pawoSD · #7 03-10-2009, 04:17 PM

My time was probably far from optimal. Ideally I'd have a third arm so I could manually shift it all the way....hold 1st and 2nd real long, then use third the rest of the way.....I'll try again sometime with someone else operating the camera.

TylerH860 · #8 03-10-2009, 04:19 PM

I think your transmission is slipping. I can't really tell, but thought I should ask the question just cuz.

pawoSD · #9 03-10-2009, 04:50 PM

Quote:

Originally Posted by TylerH860

I think your transmission is slipping. I can't really tell, but thought I should ask the question just cuz.

LOL, sure.

Mine shifts so firm that it shoves the car forward when it shifts.

You can see the sharp shifts by how the tach goes flying back when the shifts happen.

cmbdiesel · #10 03-10-2009, 05:01 PM

Have you checked your speedometer for accuracy?
Mine reads five over at all speeds.
Helps that 0-60 quite a bit.

winmutt · #11 03-10-2009, 05:23 PM

It looks so much faster with an 80mph speedo

pawoSD · #12 03-10-2009, 10:54 PM

Quote:

Originally Posted by winmutt

It looks so much faster with an 80mph speedo

No kidding.

My dad's SD has a 160mph speedo....it just looks depressing! And the car maxes out just a bit past the peak! ...oh well.

Actros617 · #13 03-10-2009, 11:11 PM

here's a 0-70 on my 300SD the video is a couple years old, BONE STOCK
http://www.youtube.com/watch?v=A69OtIsbkDw

I ll do one tomorrow with my current mod's straight pipe, boost controller boost gauge, tranny adjusted for high rpm shifting, egr deleted, black box removed and the dreded HOT AIR INTAKE

bgkast · #14 03-10-2009, 11:55 PM

Here is mine, also bone stock: http://www.youtube.com/watch?v=qOnuxTM2g5A Look, I'm getting bad economy.

I timed mine about the same as pawoSD; 15.5 seconds.
I got 16.5 when I timed yours Actros617

Actros617 · #15 03-11-2009, 10:49 AM

Quote:

Originally Posted by bgkast

Here is mine, also bone stock: http://www.youtube.com/watch?v=qOnuxTM2g5A Look, I'm getting bad economy.

I timed mine about the same as pawoSD; 15.5 seconds.
I got 16.5 when I timed yours Actros617

It was 16.5 is because I have not done my valve adjustment, old woorn out Bosch injector and unadjusted tranny